Aluminum mug

The handle and rolled rim survive the reconstruction. Compare the same photo with and without a texture, then inspect the inside of the cup.

No manual mesh or texture edits. The input images and their reconstructions are shared under the license shown with the input. Source photographs were resized for generation.

From GLB to a 60 mm slice

We imported the textured GLB into Blender 4.5.9 for the view above. In the GLB to STL converter, we chose millimeters, Z up and a 60 mm target height. The mesh measured 80.303 × 62.470 × 60 mm. The checker found one connected part, zero open edges and zero non-manifold edges.

PrusaSlicer 2.9.7 produced 299 layers at a nominal layer height of 0.2 mm. This was a software slicing check. Wall strength and the printed result still need a physical test.